Naujas TPMS CUB UNI SENSOR 4.0 EVO programuojamas 433MHz/315MHz daviklis, Vilnius

Naujas TPMS CUB UNI SENSOR 4.0 EVO programuojamas 433MHz/315MHz daviklis



New generation of Uni-Sensor sensors



Uni-Sensor 4.0 EVO is the latest generation of the popular Uni-Sensor series TPMS sensors. The EVO sensor combines the most important advantages of its predecessors: Uni-Sensor 2 and Uni-Sensor DUO. As a result, it is distinguished by its small size and light weight of 18 grams (a light sensor makes it easier to balance the wheel). It is also dual-band - in addition to the 433 MHz frequency, it also supports 315 MHz (used in cars from the American market). The new sensor also means optimized power management and long life.



Compatible with Sensor-AID programmers



The sensor is supported by all models of Cub's Sensor-AID series programmers (including the latest Sensor-AID 4.0 EVO). For diagnostics/programming in the programmer slot, it does not require any additional adapters or adapters. Supported TPMS Cub programmer models:



Sensor-AID Pro

Sensor-AID Pro 3.0

Sensor-AID Truck

Sensor-AID 4.0

Sensor-AID 4.0 EVO

One sensor for all cars



All sensors in the Uni-Sensor series are universal. This means that each sensor can be activated and repeatedly programmed for virtually all vehicles available on the European market and equipped with a direct TPMS system (and thanks to the support of the 315 MHz frequency, it will also work with cars from the American market). Any TPMS sensor diagnostic device can be used to perform the sensor status diagnosis itself.



Replacement or duplicate



The Uni-Sensor can be used as a replacement for a damaged or non-functioning original TPMS sensor without the need to reprogram the car's computer. The sensors can also be used in a second set of wheels, where they will behave like the original sensors. They can be programmed as replacements, which will fit the specified car model, but will have a different ID number. You can also make a duplicate of the original pressure sensor, using the same ID.



Replacement aluminum valve



The valve is not permanently integrated into the sensor - it can be easily removed and replaced, leaving the sensor itself. A bolt-on aluminum valve TPMS-17 is supplied with the sensor. Thanks to the unified valve mounting on the sensor,it can be easilyreplaced with a Snap-in rubber valve TPMS-11 if necessary .



Advantages of the Uni-Sensor



long-life battery, the device can operate on a single battery for up to 7 years,

the sensor will start working only after programming and activation,

supports 433 MHz (Europe) and 315 MHz (USA) frequencies,

programmable as a duplicate or replacement,

sensor can be reprogrammed up to 100,000 times,

programmable wirelessly or wired,

installation on the rim via a valve (twist-on aluminum or rubber pull-through),

easy replacement of the valve itself,

IC's and ISO 9000 manufacturing standards.

Reliable and cost-effective TPMS solution



Uni-Sensor pressure sensors are the ideal replacement for original TPMS sensors. Uni-Sensor is functionally equivalent to the original sensor, and much cheaper than it. An additional advantage is that it can be reprogrammed if necessary. The sensor can be fitted to most rims without any problems, which has been confirmed by leading rim manufacturers, who have created lists with fits of the most popular sensors to the rims they produce.